Bathroom Tile Ideas Designs and Inspiration

Bathroom Tile Ideas Designs and Inspiration

Setting out

This is the most important stage in tiling, accuracy here is essential to the overall – of the finished job. First, plan exactly whc the whole tiles will be fixed and work c where cut tiles will be the least noticear This is a relatively easy task on a blank ws find the centre of the wall and work our whole tiles from that point outwards. M walls, however, contain some kind of obs cle such as a window or door. If this is t case, decide on the room’s natural ceni point that is, the point to which your e is naturally drawn and start tiling trc there. But use your tiling gauge (see pi 108109) to ensure that you are not going have ugly slivers of tile in obvious p-i before you lay your first tile. In most cai you will be tiling to the skirting board floor and it is unlikely that either of these v. be level. It is essential that you establish a tr horizontal and tile from that to ensure tr each row is level. This is called marking
Marking out

Bathroom Tile Ideas Designs and Inspiration Photo Gallery

Using a batten and spirit level, draw a horizontal line along the wall to be tiled, ar three-quarters of a tile’s width above the

Hundreds and hundreds of tiny tiles look very matching them up into even rows. Some brands of tiny tiles are available already plastered onto larger squares to make the task less arduous. However, the end result achieves a very pleasing effect.

1 Plot a horizontal line no deeper than three-quarters of 2 To ensure the tiling will be level, fix a horizontal bar the depth of the tile. Measure out the tiles with the gauge. to the wall. Check accuracy with the spirit level ar skirting board. Make sure that at no point is the line more than a tile’s width above the nnishing level – floor or skirting board. If it . redraw the line lower down or you will be left with unworkable slivers of tile.

The tiles will need some support while the adhesive dries. Fix a line of battens on the wall with masonry nails, aligning the top of the batten with the pencilled horizontal guideline. Do not fix battens too securely or removing them will be difficult.

Using your tiling gauge, establish where the outer edge of the last whole tile on a wall will be. Mark the wall by snapping a chalk line against it, and fix a vertical batten to the wall, again aligning the inside edge of the batten with the pencilled guideline to mark the edge. Check that the battens form an exact horizontal and vertical before you start tiling.

Maybe You Like Them Too

Leave a Reply

7 + 3 =